Nvidia 680I LT SLI Bedienungsanleitung PDF herunterladen (Seite 17)

Mainboard nForce 680i SLI/

Mainboard nForce 680i LT SLI

Connectors

Floppy Disk Drive Connector: FLOPPY

These mainboards provide a standard floppy disk drive connector (FDD) that supports 360KB/

720KB/ 1.2MB/ 1.44MB/ 2.88 MB floppy disk drives using a FDD ribbon cable.

Hard Disk Drive Connectors: IDE

These mainboards provide one IDE connector that supports Ultra ATA 33/66/100/133 IDE

devices. You can attach a maximum of two IDE devices, such as hard disk drive (HDD),

CD-ROM, DVD-ROM, etc. using an IDE ribbon cable.

In general, two IDE devices can be attached onto one IDE connector. If you attach two IDE

HDDs, you must configure one drive as the master and the other one as the slave. In this case,

one optical device i.e., CD-ROM, DVD-ROM…etc. should be attached to this connector as

well.

SATA II Connector: SATA A0/A1/B0/B1/C0/C1

The six SATA II connectors support 3 Gbps transmit rate, and one SATA connector only can

attach one SATA HDD of each time using SATA cables.

Pin Assignment Pin Assignment

1 GND 2 TX+

3 TX- 4 GND

5RX+ 6 RX-

SATA A0/ A1/ B0/

B1/ C0/ C1

7 GND

Attention

The FDD/ IDE cable is designed and should be attached with a

specific direction. One edge of the cable will usually in color such

as red, to indicate that should line up with the header pin-1.

This mainboard supports RAID 0/ 1/ 0+1/ 5/ JBOD mode; refer

Appendix II for more information.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 79 80

Keine Kommentare

Nvidia 680I LT SLI Bedienungsanleitung Seite 17